The Volt "Top Dog" Tommy Light

The Volt Top Dog Tommy light was suggested by one of our contractors so we named it after him.   Perfect for task lighting and outdoor kitchens/structures.   It can be used as a standard uplight/spotlight when affixed to a stake... but the flush cut glare shield gives it a modern look for contemporary homes.  However when the versatility comes in when you use the surface mount and downlight.  Affix it to ceiling and structure and it makes a great surface mounted light when you can't install a recessed can.  Attach to a wall for task lighting.  Adjust the glare guard to get the fixture "look" you need.  Great 360 glare control!

Constructed from Heavy Duty cast brass, the Top Dog Tommy Light will last you and your family for a long long time. It's built from the same basic chassis as the Top Dog Uplight, but comes with a squared off light shield to better direct the light where it's need without creating glare. You can remove the shade, as with all of our products of a similar type, to get a much fuller spread of light on the intended area.

Here are some other Volt Products that you might like.

• Top Dog Cast Brass Spot Light
• Commercial PAR-36 Well Light

Technical Specs.

• Unique, Volt Corp special features: the industry’s most corrosion resistant socket made from beryllium copper.
  
• Tinned copper lead wire to reduce corrosion and increase fixture longevity, 25 foot long 16 gauge, SPT-2 lead wire for faster installation, flexibility and ability to relocate fixture after install.
  
• Stainless steel bulb clip holder to prevent bulb from loosening after install.
  
• UL braided sleeve protectors over internal wiring to prevent chaffing, mirror reflector for maximizing light output and heat shielding internal wiring.
  
• Silicon sealed, rubber wire guard bushing at fixture exit to prevent chaffing and moisture intrusion into fixture.
  
• O-ring sealed cap assembly.
  
• Socket and external screws pre-greased with dielectric grease to prevent corrosion and insure fixture longevity.
• 12v, low voltage fixture for downlighting
• Solid Brass with bronze finish.
  
• Extra long squared off glare guard.
  
• Silicon sealed where lead wire exits fixture so water can not enter fixture from back side.
• Fixture body sealed shut via threaded body onto o-ring seal.
• Lead wire spliced to socket wire with heat shrink tubing so no moisture can enter internal splice
• Fixture socket and threads pre-greased with dielectric grease.
• Great glare protection.
• Large glare guard adjusts up, down, left, right to adjust light spread and glare control.
  
• Glare guard is a separate piece from the sealed dome lens fixture body so you can even remove the glare guard for maximum flood spread.
  
• Built with exceptional components—tinned copper wiring, beryllium copper socket, o-ring sealed, machine threaded body, pre-greased with dielectric grease for maximum corrosion resistance.
  
• Compares to competitors $150+ fixtures.
• Uses MR-16 lamp (order from pull down menu).
• Recommended wattage for most down lighting is 20w for a natural effect.
  
• Includes solid brass tree/surface mount
• LIFETIME WARRANTY